Pro-C (older models)(with Manual All Station dial position) Turn the dial to the RUN position. Remove the 9V battery. Hold down the , and program buttons simultaneously. While holding down the three buttons, press and release the Reset button on the back of the front panel. Release all three buttons. Click to see full answer. Likewise, people ask, how do I reset my Hunter Pro C?Press and release the RESET button on the right side of the controller. Wait 2 seconds and release the , and buttons. The display should now show 12:00am. All the memory has been cleared and the controller may now be reprogrammed. how do you test a hunter sprinkler system? To initiate the test program: Press and hold the PRG button. The station number will be flashing. Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes. After a 2 second pause, the test program will begin. Subsequently, one may also ask, how do I reset my hunter sprinkler system? Resetting a Hunter X-Core is easy. To reset the irrigation controller, all you need to do is press the negative, the hand and the program keys at the same time, then use a small tool to press in the small reset button on the side of your controller. A small screwdriver or a pen will do the trick.Why does my irrigation system finish watering and then start again?A common reason for a controller to repeat a cycle is too many programmed start times. When a station has completed its watering time, the controller will switch to the next station in that program automatically.