How to Change the Belt on a Shark Vacuum Cleaner Unplug the vacuum, remove and empty the dust cup, if applicable, and lock the vacuum in the upright position. Remove the screws holding the roller cover, using a flat-head or Phillips screwdriver, depending on the model. Grasp the end of the roller farthest from the belt and angle that end out of the holder. Click to see full answer. Accordingly, how do you change the belt on a shark rotator pro? No parts specified. Step 1 Roller Brush. Flip the base of the vacuum over to access the bottom. Remove the nine 16 mm screws using the Phillips #2 Screwdriver. Pull up on the cover and move it to the side. Remove the two 11 mm screws using the Phillips #2 screwdriver. Pull out the roller brush. Step 7 Roller Belt. Beside above, how do you change the belt on a shark DuoClean? No parts specified. Step 1 Garage Door. Step 2 Side Component. Turn the T10 Security Torx screwdriver counterclockwise to remove the 15mm screw. Use the iFixit Opening Tool to pry the side of the vacuum open. Remove the side component with your hands. Step 6 Drive Belt. Repeat on the other side of the vacuum. In respect to this, why is the brush on shark vacuum not spinning? If the roller brush is not spinning, the vacuum becomes hard to push. To clean the roller brush, carefully cut out the debris accumulated around the roller brush. Once clean, check if the brush is intact. Additionally, the roller brush may not be spinning because the motor stopped running.Do Shark vacuums have belts?A great number of Shark vacuum cleaners have a belt which operates the cleaning head. When it comes to the models of older generation, they don’t have on option of automatically stopping the motor. Due to this disadvantage, the Shark vacuum belt breaks before the motor is switched off.